SAB® tex 2000

Store No: sabgate-1616587480
Product ID: 00000199
Width:
Height:
Qty: 0
Brand: SAB Insulation Systems
Shop Name: SAB GATE L.L.C
Estimated Shipping Time: 5.

Out Of Stock

AED 125

Color

#000000

Quantity

1 Pail
Out Of Stock


High Performance Rubberized Bitumen Emulsion Coating

SAB® Tex 2000:

Is an emulsified bituminous coating modified with a minimum 15% rubberized polymer content. This high-performance emulsion dries to form a tough and seamless, flexible water and vapor proof protective coating.

TYPICAL USES

Can be used for a wide variety of applications, which includes the following:

· Waterproofing & Protective Coating on concrete foundations.
· As dampproof membrane in general construction.
· Waterproofing in wet areas such as toilets, kitchens etc.
General vapor proof coating for both interior -exterior floors & walls.

ADVANTAGES

· Cold­ applied.
· Single ­component.
· Easy ­to ­apply.
· Can ­be ­applied ­on ­damp­ substrates.
· Asbestos­ free, ­odorless. ­Non-toxic, environmentally friendly.
· Can­ be­ applied in closed or ­confined spaces.
· ­Low ­VoC.
· Resistant­ against ­chloride­ and­ sulphate ions.
· Good­ adhesion ­to ­most ­building ­substrates.
· Seamless/joint ­free

AREA OF USE:

For waterproofing most building surfaces e.g. roofs, foundations, retaining
walls, swimming pools, planters, wet room floors, and water tanks etc.

PRIMING
It is highly recommended to apply a priming coat prior to the application of the
SAB® Tex 2000 coating on the substrate. The primer can be prepared in the site
by diluting SAB® Tex 2000 with 20% water and applying this diluted coat as the primer. For very dry and porous substrates apply two coats of this primer. The
primer can be applied to damp or freshly cast concrete surface also. However,
it should not be applied on waterlogged or flowing water areas.

(The properties shown below were obtained under laboratory conditions).


Color

Dark Brown Liquid

Specific Gravity

1.0± 0.05

Solid Content

60±5 %

Rubber Content

>15 %

Elongation

1000 %

Drying time @ 25°C

60 minutes

Application temperature, [°C]

5 to 55°C

Service temperature, [°C]

-5 to 100°C


APPLICATION RATE
The rate will depend on the porosity of the substrate. The following coverage
rates can be expected when the coating applied at different coverage rates:
2 - 3m²/L/coat.

PACKAGING

20kg pail & 200kg Drums

STORAGE
Store out of direct sunlight, clear of the ground on pallets.
Shelf life is 12 months when stored as above.

TECHNICAL DATA SHEET


Do not accept the product if you find the packaging is damaged


Customer Reviews:


No Review







Related Products